The aim of this blog is to connect fly-tyers all over the world, to share, techniques, patterns, information and knowledge.

Fly Tying Course # 13 The H & L Variant dry fly

IMG_1676

Heres an American Classic to tie and try over the holidays. The H & L or House and Lot as it is also known was said to be President Dwight Eisenhower’s favorite trout pattern, especially for fishing Eastern streams. Like most of the fat boy attractors this pattern should be over dressed, a little longer, larger and fatter than normal. This pattern should float high and dry, creating and irresistible footprint when drifted  over the feeding window of any trout.  Otherwise I dont know much about the history of this pattern, if  one of you do, please post a little info if you have time, it would be good to know more. Happy holidays to you all.

Hook: Mustad R30NP-BR # 10-18

Thread: Dyneema

Tail: Calf tail hair

Abdomen: Stripped peacock herl natural

Thorax: Peacock herl

Wings: Calf tail hair

Hackle: Brown

 

IMG_1614 

1

Secure your hook in the vice making sure that the hook shank is horizontal.

 IMG_1616

2

Attach your tying thread and run a foundation over the hook shank until the tying thread hangs plumb with the hook barb.

 IMG_1621

3

Cut a small bunch of calf tail hair and clean with a tooth brush. Once you have removed all the shorter hairs stack the bunch in a hair stacker.

 IMG_1626

4a

Many fly tyers have a problem with exchanging a bunch of stacked hair from one hand to the other! Heres how you do it:

Once you have removed the bunch of hair from the stacker hold it between your right finger and thumb.

 IMG_1628

4b

Now place your left hand thumb against the hair and your right thumb.

IMG_1629 

4c

Once you have trapped the hair between both your thumbs keep the pressure on.

 IMG_1630

4d 

While keeping both your thumbs pressed together trapping the hair bunch, remove your right index finger.

 IMG_1631

4e

Now bring your left index finger into the equation and grasp the butt end of the bunch against your left thumb.

 IMG_1632

4f

Remove your right thumb and your hair bunch has been transfered from right to left hand without messing it up.

 IMG_1618

5

Measure your tail length.

 IMG_1619

6

Tie in the calf tail on top of the hook shank and about half way between the hook eye and the bend. Leave a few mm of hair flared.

 IMG_1620

7

Trim off the flared hair at an angle.

 IMG_1623

8

Tie down the calf hair and apply a drop of varnish to the whippings.

 IMG_1633

9

Prepare another bunch, a little larger than the first one,  of calf tail hair and tie in as shown on top of the hook shank.

 IMG_1634

10

Cut off the flared ends at an angle again. This will give a good foundation for a tapered body later.

 IMG_1635

11

Before you tie them down apply a small drop of varnish to the trimmed calf tail.

 IMG_1637

12

Now run tying thread over the whole body making a fine taper.

 IMG_1636

13

Fold the wing back and build a small support of tying thread in front of the wing base.

 IMG_1638

14

Split the calf tail into two equal wings and tie each one down at the wing base, making a V wing.

IMG_1622 

15

Take a long peacock herl and strip only 1/3 of the herl from the quill. This will make the abdomen and thorax tying process all in one.

 IMG_1641

16

Tie in the stripped end of the herl at the tail base. You can give the under body a thin coat of varnish before you start wrapping the quill.

 IMG_1642

17

Attach a hackle plier to the herl end of the quill. Now wrap the quill in tight even turns over the rear body, when you come to the part of the quill with the herl on it, continue wrapping to form the abdomen.

 IMG_1643

18

Once you have wrapped the herl abdomen tie off and remove the excess herl.

 IMG_1644

19

Tie in a nice brown dry fly hackle. This ideally should be a long hackle, but if you only have short hackles you can tie in two. Make sure that your hackle is 90 degrees from the hook shank.

 IMG_1647

20

Start winding your hackle with one or two turns through the herl thorax and then forward making the hackle as dense as possible. Tie off and remove the excess hackle.

 IMG_1650

21

Whip finish and varnish the head. 

5 responses

  1. david

    Nice work and great photo layout. I like the use of calf tail, as I have a lot of it!

    January 7, 2014 at 12:41 pm

  2. Anonymous

    Nice looking fly Barry! Thank you for sharing with us! 🙂

    January 8, 2014 at 2:32 am

  3. Tom

    Last comment ^

    January 8, 2014 at 2:34 am

  4. Why go through all the “issues” with switching stacked hair between hands? All you have to do is take it out of the stacker in the direction its going to be tyed in.

    January 8, 2014 at 4:22 am

    • Hi Ross, If you are using , lets say, materials that can’t be stacked in a hair stacker! Like hackle fibers, for tails that you strip with your finger and thumb directly from the hackle stem, to keep the points even. Or when you need too switch hands when measuring tail, wing and shell back length to get proportions right, this technique works very well, try it!

      January 8, 2014 at 8:22 am

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s