The aim of this blog is to connect fly-tyers all over the world, to share, techniques, patterns, information and knowledge.

Bug Bond Thunder Creek.

Bug Bond Thunder Creek, a great salt water sea trout pattern.

The original Thunder creek streamer series came from the vice of American, Keith Fulsher. In the early sixties, not satisfied with the regular head and eye size of streamers, he began experimenting and chose the reverse buck tail technique for his Thunder creek patterns.  This technique involves tying the buck tail, as the technique suggests, the opposite way and then folding it back over the hook shank and tying down to form the head. The simplicity of this pattern and the minimal materials needed to tie it, is fly design at its very best! He achieved his goal, a slim two toned body with a large minnow head that allowed for larger eyes, the main attack point for predatory fish and through changing only the buck tail colour and hook size, could imitate numerous baitfish. Streamers generally fall into two categories, baitfish imitations and attractors! I am in no doubt that the Thunder creek covers both. You can try a whole load of colour combinations, and if you would like a little flash in the pattern tie this in at the rear of the head before folding the wings back. Also if you would like a heavier pattern use lead under the head dubbing.  If you are looking for a slimmer pattern to imitate a sand eel, replace the buck tail with a synthetic material like fish hair or DNA, but dont build up the head with dubbing, this will keep the pattern slim and streamline.

1
Secure your straight eye streamer hook securely fixed in the vice.

Attatch your tying thread and cover the first third of the hook shank.

3
Now cut a small bunch of buck tail and even the ends in a hair stacker. measure the hair bunch to the correct length required and tie in as shown, on top of the hook shank.

4
Turn your hook up side down in the vice.

5
Tie in another bunch of lighter buck tail on the underside of the hook shank. This should be just a little shorter than the first. Make sure that the forward whippings of tying thread are tight into the hook eye.

6
Now apply a little dubbing to the tying thread and build up a tight dense base for the head of the baitfish. Make sure that the head is not larger than the initial butts of buck tail. Finish with the tying thread hanging at the base of the head.

7
This stage can be done free hand, but you can achieve much better results using a transparent plastic tube. Place the tube over the eye of the hook pushing the buck tail back to form the wing.

8
Make a few tight turns of tying thread to form the head. The Bucktail wing will flare outwards.

9
Carefully remove the tube, by twisting it from side to side while carefully pulling off the head. Make a few more secure tight turns of tying thread and whip finish. Apply the tape eyes one each side. To set the wing flat wet your fingers and stroke the wing.

10
The only thing remaining now is to coat the head with Bug Bond. The first coat is just to secure the tape eyes. Make sure that when applying the next two coats that you cover the band of tying thread. When the wing dry’s it will remain flat.

One response

  1. Reblogged this on thefeatherbender and commented:

    Heres another bullet head pattern for fly tying course # 7

    September 30, 2014 at 1:29 pm

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s