The aim of this blog is to connect fly-tyers all over the world, to share, techniques, patterns, information and knowledge.

Stingsild bucktail streamer

In the autumn in Northern Europe after the long hot summer when the coastal waters begin to cool down again, its at this time of year you dont want to be without a stickleback imitation!

IMG_5843

Although the recent tendency for tying and designing sea trout flies has gone more towards imitation patterns, some of which are extremely realistic, I am constantly drawn back to some more traditional styles of tying, that never stop producing fish. This is one of them!  This extremely simple pattern is so effective on autumn sea trout that for the past few years at least a couple of dozen have to be tied for my box.  During the summer months the Mickey Finn, another classic buck-tail streamer, is an outstanding pattern on bright sunny days, but falls short when fished in the autumn. I wanted a pattern that would fish as well in the dark grey autumn months, this was the result.

Stingsild Buck-tail streamer

Hook          Mustad S71SS salt water streamer # 4-6  http://mustad.no/catalog/na/product.php?id=193

Thread      Dyneema http://www.funkyflytying.co.uk/shop/products/veevus-gsp-thread-dyneema-/1266/

Body         Holographic tinsel

Throat    White buck-tail https://www.spiritriver.com/materials/hair-fur/select-bucktails

Underwing   Four strands of gold Gliss n Glow https://www.spiritriver.com/materials/flash/gliss-n-glow

Wing      Light brown buck-tail with darker brown buck-tail over https://www.spiritriver.com/materials/hair-fur/select-bucktails

Topping   Five or six strands of peacock herl

Eyes    Edson brass eyes  http://www.whitetailflytieing.com/

Head    Black  http://www.veniard.com/section154/cellire-head-cement-and-thinners

IMG_5812

1

Insert your salt water streamer hook in the vice with the hook shaft horizontal.

IMG_58132

Run your tying thread along the hook shank until you come to a place between the hook point and barb.

IMG_58153

At the tail of the hook tie in a length of holographic flat tinsel. Unlike salmon and exhibition flies this tinsel body should be uneven, I want to achieve the most reflective multi faceted surface as possible. So the foundation of thread doesn’t have to be flat!

IMG_58164

This is also a fishing fly so strengthen the tinsel body by coating the thread foundation with varnish before you start wrapping the tinsel.

IMG_58195

Wrap the tinsel over the whole length of the body and wipe off any excess varnish that may flow on to the tinsel. tie off.

IMG_58206

Turn your fly up side down and tie in a small bunch of prepared white buck-tail. This should extend about one half of the hook length beyond the hook bend.

IMG_58217

Trim off the excess buck-tail and tie down the butts with a few turns of tying thread.

IMG_58238

Tie in four short lengths of gold Gliss n Glow on top of the hook shank.

IMG_58259

Now clean and stack a small bunch of light brown or tan buck-tail and tie in on top of the Gliss n Glow.

IMG_582810

Repeat stage 9 but with a darker brown buck-tail That extends a little longer than the light brown.

IMG_582911

Cut five or six lengths of peacock herl from just under the eye on a peacock tail feather. Tie these in in one bunch for the topping, again a little longer than the buck-tail wing.

IMG_583112

Take two Edson brass eyes, you can substitute these with jungle cock but the effect is not the same.

IMG_583213

Trim down the brass eyes with wire cutters as shown.

IMG_583314

Secure the eyes one each side of the head with a few turns of tying thread. Before you continue to tie in the eyes apply a drop of varnish to hold everything in place.

IMG_583515

Wrap the head with tying thread and whip finish. Coat the head with black varnish.  Now wet your fingers and soak the entire wing and pull it back to give it shape.

IMG_583716

Once the wing is wet and shaped let it dry, it only takes a few minutes.

IMG_584317

Once dry the wing will hold its shape.

IMG_585818

A batch of Stingsild soon ready for the salt!

2 responses

  1. Nice tie.

    July 20, 2014 at 8:34 am

  2. Bill Black

    Hi Barry, many thanks for the mention of our materials. We will be sending you more on new products shortly. Bill

    Sent from where Bill is!

    >

    July 22, 2014 at 4:09 pm

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s